[Nov 27, 2024] Verified 300-615 dumps and 243 unique questions
300-615 Dumps for Pass Guaranteed - Pass 300-615 Exam 2024
NEW QUESTION # 40
Refer to the exhibit.
A new Cisco Nexus 5548 Switch connects to a network. SAN switching is configured on the switch. The switch fc2/10 NP uplink is shown in the exhibit. Which action ensures that fc2/10 is in an up state?
- A. Configure the admin port type E on the upstream switch that connects the port.
- B. Replace the SFP port module in fc2/10.
- C. Enable NPIV on the upstream switch that connects the port.
- D. Configure the BB_credit buffers on the upstream switch that connects the port.
Answer: C
NEW QUESTION # 41
Refer to the exhibit.
Sw1 and Sw2 are two Cisco Nexus 9000 Series Switches that run Cisco NX-OS. They are VTEPs in the same vPC domain. Which statement describes what happens in this scenario?
- A. Sw1 and switch 2 perform the VxLAN multicast encapsulation and decapsulation for all traffic associated with the VxLAN VNIs, depending on the hashing.
- B. Sw1 drops all traffic because there is no (S, G) OIF list to encapsulate VXLAN multicast packets and send them out to the underlay network through the uplink interfaces.
- C. Sw2 did not send an IP PIM register to the rendezvous point for the multicast group of the VXLAN VNI.
- D. Sw1 performs the VxLAN multicast encapsulation and decapsulation for all traffic associated with the VxLAN VNIs.
Answer: D
NEW QUESTION # 42
Refer to the exhibit.
An engineer deploys SAN environment with two interconnected Cisco MDS 9000 Series switches. When the engineer attempts a zone merge, it fails with the error that is presented in the exhibit. Which action resolves the issue?
- A. Change the name of one of the zones to match the other zone set.
- B. Set the distribute policy of the zone to full.
- C. Ensure that the zone members have different names.
- D. Import or export a zone set between the switches to synchronize the switches.
Answer: D
Explanation:
Explanation
https://www.cisco.com/en/US/docs/storage/san_switches/mds9000/sw/rel_3_x/troubleshooting/guide/ts_guide.pd
NEW QUESTION # 43
Refer to the exhibit. The initiator that has FC ID 0x970102 fails to communicate with the target that has FC ID 0x970200. What action resolves the issue?
- A. Reactivate the zoneset.
- B. Reset the port for FC ID 0x970209 and FC ID 0x9700c2 to log in to the fabric.
- C. Reset the port for FC ID 0x970102 and FC ID 0x970200 to log in to the fabric.
- D. Reconfigure the initiator and the target to be in the same zones.
Answer: D
Explanation:
Members of different zones cannot access each other.
https://www.cisco.com/en/US/docs/storage/san_switches/mds9000/sw/rel_3_x/troubleshooting/guide/ts_zones.pdf
NEW QUESTION # 44
A mission-critical server is connected to site A.
Connectivity to this server is lost from site B because the MAC route is missing in the OTV VDC of the Nexus 7000 in site B due to MAC aging. Which action allows the flooding of the unknown unicast MAC on the Nexus 7000 in the OTV VDC?
- A. Use route-map to advertise this MAC statically and redistribute with ISIS.
- B. Use the otv flood mac <> command to selectively flood traffic for a given MAC.
- C. Unknown unicast flooding is not allowed.
- D. Use the otv isis bfd <> command to configure BFD protocol.
Answer: B
NEW QUESTION # 45
A firmware upgrade on a fabric interconnect fails. A bootflash contains a valid image. Drag and drop the recovery steps from the left onto the correct order on the right.
Answer:
Explanation:
NEW QUESTION # 46
An engineer is troubleshooting a failed DCBX exchange between a server and a Cisco Nexus switch. Which action allows DCBX to successfully negotiate?
- A. Enable PFC.
- B. Enable LLDP.
- C. Enable ETS
- D. Enable Cisco Discovery Protocol.
Answer: B
NEW QUESTION # 47
Refer to the exhibit.
A web browser displays a "not secure" warning message when accessing the web interface of Cisco UCS Manager. Which action resolves the issue?
- A. Use the correct TCP port for HTTPS.
- B. Use a supported version of UCS Manager.
- C. Use a supported web browser.
- D. Load third-party certificate to UCS Manager.
Answer: D
NEW QUESTION # 48
A customer configures HSRP between two data centers that are interconnected with OTV. The configuration succeeds, but traffic between two ESXi virtual hosts on the same site is routed suboptimally through the OTV overlay. Which two actions optimize the traffic? (Choose two.)
- A. Filter HSRP traffic by using a Layer 3 VACL on the OTV edge devices.
- B. Filter HSRP by using a Layer 2 MAC-list on the OTV edge devices.
- C. Disable first-hop redundancy.
- D. Filter HSRP by using a Layer 2 MAC-list on the ESXi vSwitch.
- E. Filter HSRP traffic by using a Layer 3 VACL on the ESXi vSwitch.
Answer: A,B
NEW QUESTION # 49
An engineer must configure Linux hosts that are deployed on Cisco UCS B-Series Servers to boot from SAN.
The SAN boot policy is configured in Cisco UCS Manager, and the boot order is verified to be set as expected.
However, the Linux hosts fail to boot. Which action resolves the issue?
- A. Delete and reconfigure the boot LUN
- B. Delete and reconfigure the pWWN of the SAN boot target
- C. Remove all of the ISO images that are mounted as a virtual CD-ROM
- D. Remove all of the local storage that is installed
Answer: D
NEW QUESTION # 50
Refer to the exhibit.
The HSRP instance on both switches is showing as active. Which action resolves the issue?
- A. Configure the IP address of N9K-B on the same subnet as N9K-A.
- B. Configure the HSRP timers to be the same.
- C. Configure preempt on only one of the switches.
- D. Allow VLAN 100 between the switches.
Answer: C
NEW QUESTION # 51
Refer to the exhibit. An engineer configures the server port on a Cisco Nexus 5000 Series Switch.
The switch connects to an NPV edge switch port. The server fails to send the FC traffic to the fabric. Which action resolves the issue?
- A. Replace the SFP in slot fc2/12.
- B. Enable the NPIV mode on the Cisco Nexus 5000 switch.
- C. Configure the BB_credit buffer on the uplink port.
- D. Match the VSAN membership on both ends of the connection.
Answer: D
NEW QUESTION # 52 
Refer to the exhibit. An engineer is performing a health check on ACI. Which statement about interface Ethernet 1/11 is true?
- A. The interface policy is misconfigured.
- B. The interface is working correctly and fully operational, but it is not in use.
- C. "out-of-service" is the default interface status in ACI.
- D. "out-of-service" indicates that no service graph is in use for this interface.
Answer: A
Explanation:
Section: Compute Platforms
NEW QUESTION # 53
Refer to the exhibit. A network engineer notices packet drops on FCoE traffic from the servers.
Which action resolves the issue?
- A. Disable priority flow control on the interface.
- B. Enable priority flow control on the interface.
- C. Apply flowcontrol receive on the interface.
- D. Apply flowcontrol transmit on the interface.
Answer: B
NEW QUESTION # 54
Refer to the exhibit.
An engineer must connect N2K-Fex-1 and N5K-Core-1 so that the traffic flow between the two devices uses load balancing. After inspecting the statistics of the interconnecting interfaces, the engineer concludes that only one link is used. Which action resolves the problem?
- A. Configure source-destination load balancing on N5K-Core-1.
- B. Configure each uplink to be a member of a separate LACP port channel.
- C. Configure destination-mac load balancing on N5K-Core-1
- D. Configure the pinning max-link as 2.
Answer: D
Explanation:
https://www.cisco.com/c/m/en_us/techdoc/dc/reference/cli/n5k/commands/pinning-max-links.html
NEW QUESTION # 55 
Refer to the exhibit. A network engineer is troubleshooting a Cisco Nexus 5000 Series Switch. The interface between the server and the switch is nonoperational and is expected to operate at 10 Gbps. The drain rate of the interface is 3 Mbps. Which action resolves the issue?
- A. Set priority flow control pause
- B. Configure pause error-disable recovery
- C. Enable link level pause on the interface
- D. Reset priority flow counters
Answer: B
NEW QUESTION # 56
Refer to the exhibit. The EEM applet must generate a syslog message when a BGP adjacency flaps. This message must be displayed to the console of the switch. However, when a BGP adjacency failure is simulated, no syslog message is displayed. Which action resolves the issue?
- A. Modify the policy to use the snmp trap action.
- B. Adjust the policy to match an SNMP OID.
- C. Add the event-default action statement.
- D. Set the logging priority to Wamings.
Answer: D
NEW QUESTION # 57
Refer to the exhibit.
A network engineer is implementing a Cisco UCS environment. The environment consists of eight servers configured with the same service profile template and Windows 2012 installed. The VFC interfaces of five of these servers are showing the error shown in the exhibit. Which action resolves the issue?
- A. Modify the vHBAs name in the storage connectivity policy
- B. Modify the boot order in the boot policy
- C. Configure upstream zoning
- D. Decommission and recommission the servers
Answer: D
NEW QUESTION # 58
Refer to the exhibit. An engineer deploys SAN environment with two interconnected Cisco MDS
9000 Series switches.
When the engineer attempts a zone merge, it fails with the error that is presented in the exhibit.
Which action resolves the issue?
- A. Change the name of one of the zones to match the other zone set.
- B. Set the distribute policy of the zone to full.
- C. Ensure that the zone members have different names.
- D. Import or export a zone set between the switches to synchronize the switches.
Answer: D
Explanation:
https://www.cisco.com/en/US/docs/storage/san_switches/mds9000/sw/rel_3_x/troubleshooting/guide/ts_guide.pdf
NEW QUESTION # 59
Refer to the exhibit. During implementation of a Cisco UCS C-Series Server, an engineer receives the status that is shown in the exhibit. Which action resolves the issue?
- A. Insert an SD card into SLOT-2
- B. Configure the RAID that is associated with the card.
- C. Set SLOT-1 Sync Mode to "Auto"
- D. Reconfigure the Drive Type from "Removable" to "Non-Removable"
Answer: D
NEW QUESTION # 60
Refer to the exhibit.
An engineer configures the server port on a Cisco Nexus 5000 Series Switch. The switch connects to an NPV edge switch port. The server fails to send the FC traffic to the fabric. Which action resolves the issue?
- A. Replace the SFP in slot fc2/12.
- B. Enable the NPIV mode on the Cisco Nexus 5000 switch.
- C. Configure the BB_credit buffer on the uplink port.
- D. Match the VSAN membership on both ends of the connection.
Answer: D
NEW QUESTION # 61
Refer to the exhibit. Sw1 and Sw2 are two Cisco Nexus 9000 Series Switches that run Cisco NX- OS. They are VTEPs in the same vPC domain.
Which statement describes what happens in this scenario?
- A. Sw1 and switch 2 perform the VxLAN multicast encapsulation and decapsulation for all traffic associated with the VxLAN VNIs, depending on the hashing.
- B. Sw1 drops all traffic because there is no (S, G) OIF list to encapsulate VXLAN multicast packets and send them out to the underlay network through the uplink interfaces.
- C. Sw2 did not send an IP PIM register to the rendezvous point for the multicast group of the VXLAN VNI.
- D. Sw1 performs the VxLAN multicast encapsulation and decapsulation for all traffic associated with the VxLAN VNIs.
Answer: D
NEW QUESTION # 62
......
Cisco 300-615 certification exam is designed to test the knowledge and skills of IT professionals who are responsible for troubleshooting data center infrastructure. 300-615 exam is part of the Cisco Certified Specialist - Data Center Operations certification track and is intended for individuals who have a deep understanding of data center infrastructure, including storage, compute, network, and virtualization technologies. 300-615 exam covers a range of topics, including troubleshooting methodologies, storage infrastructure, networking infrastructure, compute infrastructure, and management and automation tools.
Cisco 300-615 (Troubleshooting Cisco Data Center Infrastructure) Certification Exam is designed for IT professionals who wish to demonstrate their skills in troubleshooting complex data center infrastructure issues. Troubleshooting Cisco Data Center Infrastructure certification exam is part of the Cisco Certified Specialist - Data Center Operations certification track and validates an individual’s knowledge and skills in identifying and resolving problems related to Cisco data center infrastructure technologies.
Latest 100% Passing Guarantee - Brilliant 300-615 Exam Questions PDF: https://www.practicematerial.com/300-615-exam-materials.html
300-615 Exam Dumps - Try Best 300-615 Exam Questions: https://drive.google.com/open?id=1NdPw6bEfEdbR0kGUb-L_yUyjIE0HfyhE
