Use the best ways of preparing for 301a Exam Dumps with PracticeMaterial F5 301a dump PDF [2022]
F5 301a exam candidates will surely pass the Exam if they consider the 301a dumps learning material presented by PracticeMaterial.
NEW QUESTION 62
AN LTM Specialist needs to determine the delay between an LTM device and the internal web server for a specific client.
Which two AVR reporting options should the LTM Specialist enable to measure the delay? (Choose two.)
- A. Methods
- B. Client IP
The problem is to specify the server delay of the client - C. Response codes
- D. Server latency
- E. User agents
Answer: B,D
NEW QUESTION 63
An LTM Specialist needs to provide statistics regarding the round-trip time between the clients and the servers.
Which metric should be part of the analytics profile to provide that information?
- A. Max TPS and Throughout
- B. Page Load Time
- C. User Sessions
- D. Response Codes
Answer: B
NEW QUESTION 64
A node is assigned two monitors as seen in this configuration.
What is the status of a member that runs on that node and listens on port 443?
- A. DOWN
- B. UP
- C. UNKNOWN
- D. UNAVAILABLE
Answer: D
NEW QUESTION 65
An SSL application is being migrated to the LTM device. Both encrypted and unencrypted traffic are accepted by the server. The virtual server configuration is as follows:
Which LTM device profile should be used on the LTM device to reduce the CPU load on the current.
- A. clientsssl
- B. Protocol
- C. stream
- D. serverssl
Answer: A
NEW QUESTION 66
An TLM Specialist has an Exchange that must use the LTM device to route traffic to the internet.
Which SNAT/NAT configure allows the Exchange server's traffic access the internet through the LTM device?
- A. SNAT Pool
- B. NAT
- C. SNAT Automap
- D. SNAT List
Answer: D
NEW QUESTION 67
The picture belongs to static content, you can configure static content cache in FS to meet this demand An LTM Specialist must configure session persistence for a highly available, highly utilized web-based application.
* The following requirements are provided:
* http proxy setup for security
persistence information available to the HA peer in case of failover
The LTM Specialist needs to minimize additional burden on the LTM device to the greatest extent possible.
Which persistence profile should be used?
- A. Destination Address Affinity
- B. Source Address Affinity
- C. Universal
- D. Cookie insert
Answer: D
NEW QUESTION 68
A web server's default gateway is the network router. The LTM Specialist needs to introduce an LTM device to load balance to the web servers without changing the server's default gateway.
Which deployment method and settings should the LTM Specialist use to ensure correct traffic flow and that the web servers can obtain the actual con IP addresses?
- A. SNAT deployment with automap configured and X-Forwarded-For inserted in HTTP headers
- B. SNAT deployment with automap configured
- C. route deployment without SNAT configuration
- D. route deployment with Automap configured and X-Forwarded-For inserted in HTTP headers
Answer: A
NEW QUESTION 69
An LTM device an application that requires all connections to be secured via SSL The device must verify that request contain a specific cookie before allowing the request to be sent to the pool member.
Which virtual server type should an LTM Specialist configure on the LTM device?
- A. Performance (HTTP)
- B. Performance (Layer 4)
- C. Standard
- D. Stateless
- E. Forwarding (IP)
Answer: C
NEW QUESTION 70
Exhibit.
The LTM devices LTM1 and LTM2 are configured in a Device Group (Sync Failover) with Network Failover configured on both the management and HA and Internal VLANS. and ConfigSync is confined in a Device Group (Sync Failover) with Network Failover and internal are tagged on a single trunk with subnets Connection Mirroring is configured on both the HA interlace directly connected between LTM1 and LTM2, and the management interlace is connected to a management switch. The LTM devices have four Traffic Groups defined, and both LTM devices are healthy and capable of passing traffic for any of the Traffic Groups.
An LTM Specialist disconnects the cable for the HA network in an effort to test failover.
Which HA functionality works in this case?
- A. ConfigSync works. Connection Mirroring docs NOT work
- B. ConfigSync works Connection Mirroring works
- C. ConfigSync does NOT work; Connection Mirroring works
- D. ConfigSync does NOT work. Connection Mirroring floes NOT work.
Answer: C
NEW QUESTION 71
An LTM device provides load balancing to a web application? The LTM device has two dual-core processors and a licensed SSL Transactions Per Second (TPS) limit of 500 CMP is enabled.
TLS connections are used between client systems and virtual servers on the LTM device, as well as from the LTM device to servers used as part of LTM pool.
TLS enabled virtual servers utilize certificates based on 2048-bit keys During a peak period. 2560 new TLS transactions per second are attempted to the web application via the LTM device.
What will happen in this scenario?
- A. Nothing: TLS transactions per second are NOT affected by an SSL TPS license limit
- B. Nothing: 2560 TLS transactions per second is within the SSI TPS license limit.
- C. 560 new TLS transactions will be silently discarded due to the SSL TPS license limit
- D. 2060 new TLS transactions will be silently discarded due to the SSL TPS license limit
Answer: C
NEW QUESTION 72
Refer to the exhibit
Given the bigip conf extract shown where the servers only talk http on port 80, which node will receive the next user request?
- A. 10.1.1.2 0
- B. 10.1.1.3
- C. 10.1.1.1
- D. 72.10.1.1
Answer: B
NEW QUESTION 73
Exhibit.
- The ITM devices LTM 1 and LTM2 are configured in Device Group X (Sync-Failover)
- LTM3 and LTM4 are configured in Device Group Y (Sync-Only)
- An LTM specialist configures Device Group Z (Sync-Only) to keep several profiles in (sync-Only) to keep several profiles in sync across all devices.
- Device GROUP X has four Traffic Groups A, B, C and D configured.
- Device Group Y has four Traffic Groups E, F, G, and H configured
- Auto Fallback IS NOT Enabled.
- Each Device group is healthy and able to pass traffic for any traffic group assigned to that Device Group.
The data center that contains LTM2 and LTM4 loses power. After 10 minutes; power is restored and all devices are up and healthy.
What is the state of each Traffic Group on each ITM device after power is restored?
A)
B)
C)
D)
- A. Option D
- B. Option C
- C. Option B
- D. Option A
Answer: D
NEW QUESTION 74
An LTM Specialist needs to terminate client SSL traffic and based on the cookie presented by client.
Which set of profiles should the LTM Specialist use?
- A. HTTP, Server SSL, SSL Cookie Profile
- B. HTTPS, Server SSL, SSL Cookie Profile
- C. HTTP, Client SSL, Cookie Persistence Profile,
- D. HTTPS, Client SSL, Cookie Persistence Profile
Answer: C
NEW QUESTION 75
An LTM Specialist needs to assign a health monitor to a pool with two pool members 10.10.10 101 and 10.10.10.102 Both pool members are listening on port 8080 with TCP. The health of the application depends on the health of an another server (10 10 10 100) that runs port 9080 with TCP.
Which two custom TCP monitors should be selected as the pool's health monitors' (Choose two)
- A. a custom TCP monitor that works on port 9080 with 10.10.10.100 as alias address
- B. a custom TCP monitor that works on port 8080 with 10.10.10.101 as alias address
- C. a custom TCP monitor that works on port 8080
- D. a custom TCP monitor that works on port 9080,
- E. a custom TCP monitor that works on port 9080 with 10,10.10.101 as alias address
- F. a custom TCP monitor that works on port 8080 with 10.10.10.102 is alias address
Answer: A,C
NEW QUESTION 76
Consider the monitor configuration displayed below.
What is the status of a pool member that responds with ''200 OK''?
- A. down
- B. disabled
- C. available
- D. unknown
Answer: A
NEW QUESTION 77
What should the LT'M Specialist add to the virtual server?
- A. one Stream profile with the expression of @http:// @https:// @
- B. two Stream profiles and an iRule with the command of STREAM expression (@http:// @https:// @@internalapp@publicapp@)
- C. Two Stream profiles, one profile for each rewrite requirement
- D. one Stream profile and an iRule with the command of STREAM expression (@http:// @https:// @@internalapp@publicapp@)
Answer: D
NEW QUESTION 78
Refer to the exhibit.
The http monitor is applied to a pool. All members are enabled. One server responds as follows.
What is the resulting status of this poo! member?
- A. Unavailable (Disabled)
- B. Offline (Enabled)
- C. Offline (Disabled)
- D. Available (Enabled)
Answer: B
Explanation:
The first picture "Send String" and "Receive String" are not clear. Send String should be "GOOD", the response packet does not contain this keyword. Receive Disable String is completely unclear. If the response packet contains the content of Receive Disable String at this time, it will be Available (Disabled), If the content of Receive Disable String is not included, then Offline (Enabled).
NEW QUESTION 79
An LTM specialist needs to create a new account with the admin role called "newadmin' and access to all partitions.
Which tmsh command should be executed?
- A. create /auth user newadmin partition-access add {all-partitions {role admin }} prompt for-password.
- B. create /users newadmin partition-access add {all-partitions {role admin JJ prompt for-password.
- C. create /user newadmin partition-access add (all-partitions {role admin }} prompt- for-password.
- D. create / sys user newadmin partition-access add (all-partitions {role admin )} prompt-for-password.
Answer: A
Explanation:
Examining the use of commands, the creation of user is subordinate to auth
NEW QUESTION 80
An LTM Specialist needs to gather website statistics such as latency and throughput on the existing virtual server. This virtual server load Balances the backend web servers.
Which F5 feature will provide this?
- A. the Performance panel
- B. the AVR module
- C. the Dashboard
- D. the Statistics panel
Answer: B
NEW QUESTION 81
TWO LTM devices are in the same Device Group and configured for Ac live/Standby Failover. The LTM Specialist observes that the HA Active and Standby device constantly changes state. All network links use the default route domain A dedicated fiber ink is used for the HA connection with a latency of 250 ms but no packet loss.
What is causing the change in failover state to occur?
- A. The HA network is using the default routing domain.
- B. The HA network is not configured for mirroring.
- C. The HA network is using multicast IP.
- D. The HA network latency is too high.
Answer: C
Explanation:
NEW QUESTION 82
Exhibit.
The three VLANS shown provide connectivity to backend servers. The backend servers are being moved to unmanaged switches and require separate interfaces.
How should the F5 device interfaces be configured?
- A. Create VLAN named VLAN_A enter 100 under Tag and move interface 1.1 to tagged Create VLAN_B enter 200 and move interface 1.2 to tagged Create VLAN_C Center 300 and move interface 1.3 to tagged.
- B. Create a Trunk interface and select VLAN_A, VLAN_B. and VLAN_C.
- C. Create VLAN_A move interface 1.1 to untagged. Create VLAN_B move interface 1.2 to untagged. Create VLAN_C move interface 1.3 to untagged.
- D. Create a Trunk interface and combined interface 1.1.1.2 and 1.3.
Answer: C
NEW QUESTION 83
Two LTM devices must be manually configured to restrict in the same Device Group.
What is the correct order of steps to meet this requirement?
- A. Configure Self-IPs, Configure VLAN, Configure Config-Sync IP. Configure Failover type, Establish Device Trust, Sync Device Trust, Create Device Group
- B. Configure VLAN, Configure Config-Sync IP. Configure Self-IPs. Configure Failover type. Establish Device Trust, Create Device Group
- C. Configure VLAN, Configure Self-IPs, Configure Config-Sync IP. Configure Failover type, Establish Device Trust, Sync Device Trust, Create Device Group.
- D. Configure VLAN, Configure-Sync IP, Configure Failover type, Establish Device Trust, Sync Device Trust, Create type, Establish Device Sync Device Trust, Create Device Group.
Answer: C
NEW QUESTION 84
Which process can be eliminated by terminating SSL communication on the LTM device rather than the backend pool members?
- A. applying security patches on the backend pool members
- B. obtaining SSL certificates from a certificate authority
- C. administering SSL on the web servers
- D. generating CSRS
Answer: C
NEW QUESTION 85
An LTM Specialist needs to upgrade all guests on a Viprion eight CMP guests.
What is the maximum number of guests that the LTM Specialist should upgrade at once?
- A. Eight
- B. One
- C. TWO
- D. Four
Explanation
Each guest is independent, just like hardware upgrades. Can only upgrade one by one, there is no way to upgrade at the same time.
Answer: B
NEW QUESTION 86
Refer to the exhibit.
The pool shown is configured with four pool members in a variety of states. The application is receiving a large number of request. The LTM Specialist needs to make changes to make sure that all members receive the same levels of traffic.
Which changes need to be made?
- A. Enable 10.80.1.40 disable priority group activation, enable ratio
- B. Enable 10.80.1.40 and 10.80.1.20 disable priority group activation, enable ratio.
- C. Enable 10.80.1.40 and 10.80.1.1.20 disable group activation, enable Round Robin
- D. Enable 10.80.1.20 disable priority group activation, enable Round Robin
Answer: C
NEW QUESTION 87
......
Full 301a Practice Test and 150 unique questions with explanations waiting just for you, get it now: https://drive.google.com/open?id=1nfAncxm3tkgBu2zJ2A1Ae8y3ci2hNyRW
Accurate & Verified Answers As Seen in the Real Exam here: https://www.practicematerial.com/301a-exam-materials.html
