Use Real CSSBB Dumps - ASQ Correct Answers updated on 2021
ASQ Certification CSSBB Exam Practice Dumps
NEW QUESTION 85
One of the foundations of Lean Six Sigma is the concept that the output of a process (Y) is influenced by the process inputs (X's) and is commonly shown as which formula?
- A. Y = g(X+ 1.5)
- B. Y = f(Xn)
- C. Y = Z(X2)
- D. Y = f(X3)
Answer: B
NEW QUESTION 86
A Belt has determined that the inventory of repair parts at a rework station can be reduced by 45%. According to Cost of Poor Quality (COPQ) definitions inventory reduction would be considered _______________.
- A. Median Savings
- B. COPQ efficiency
- C. Hard Savings
- D. Soft Savings
Answer: C
NEW QUESTION 87
When analyzing the behavior of our process to assess customer satisfaction we are concerned about both the variation such that it stays within the spec limits and how well the Mean is __________________ the process requirements.
- A. Twice as great as
- B. Balanced against
- C. Centered relative to
- D. Over and above
Answer: C
NEW QUESTION 88
A Belt rearranged the location of the parts inventory for a rework station locating the most often used parts to be within hand reach of the repair person. This rearrangement resulted in quicker repair times by eliminating one of seven major elements of waste which is the Waste of __________.
- A. Motion
- B. Inventory
- C. Conveyance
- D. Waiting
Answer: A
NEW QUESTION 89
An experiment is conducted by checking the effect that three different pressures have on the surface appearance of a product. Ten items are produced at each of the three pressures. The number of replications, factors and levels are:
- A. 10, 3, 2
- B. 2, 3, 3
- C. 10, 2, 3
- D. 10, 3, 1
- E. 10, 1, 3
Answer: E
NEW QUESTION 90
Which of these might contribute to similar distributions having Unequal Variance?
- A. All of the above
- B. Multiple Modes
- C. Extreme tails
- D. Outliers
Answer: A
NEW QUESTION 91
If a Six Sigma project was to reduce changeover times and the team found the project success was decreasing over time since changeover times began to creep back up, which Lean tools should be considered in the Control Phase to reestablish and sustain the project success?
- A. Confirm a Visual Factory exists to assure proper communication of status of machines
- B. Improve the lighting to assure adequate visibility
- C. Implement Kanbans to assure enough inventory for the process step
- D. Reword the standardized work instructions to use active verbs and not passive phrases
Answer: A
NEW QUESTION 92
A management team lists nine goals across the top of a rectangle and 15 activity initiatives along the left hand side of the rectangle. If one of the activities strongly supports one of the goals a circle is placed in the box where that activity's row intersects the goal's column. If the activity's support is very strong a "bulls eye" is placed in the box and if the support is weak a triangle is used. This best describes which problem solving tool?
- A. Process decision program chart
- B. Inter-relationship digraph
- C. Affinity diagram
- D. Prioritization matrix
- E. Tree diagram
- F. Matrix diagram
- G. Activity network diagram
Answer: F
NEW QUESTION 93
Production Line 1 is able to complete 500 units per shift. Production Line 2 is able to finish 1,500 units per shift. Production Line 2 is 3 times faster than Production Line 1. This analysis is an example of ______________ Scale Data.
- A. Ratio
- B. Nominal
- C. Interval
- D. Ordinal
Answer: A
NEW QUESTION 94
With Measurement System Analysis we are concerned with two issues that impact the potential variability of the data. They are _____________________.
- A. Error and Spread
- B. Reliability and Repeatability
- C. Sensitivity and Deflection
- D. Precision and Accuracy
Answer: D
NEW QUESTION 95
A Belt working in a supply chain environment has to make a decision to change suppliers of critical raw materials for a new product upgrade. The purchasing manager is depending on the Belt's effort requiring that the average cost of an internal critical raw material component be less than or equal to $3,600 in order to stay within budget. Using a sample of 42 first article components, a Mean of the new product upgrade price of
$3,200 and a Standard Deviation of $180 was estimated. Based on the data provided, the Z value for the data assuming a Normal Distribution is?
- A. 1.11
- B. 2.22
- C. 5.42
- D. 4.30
Answer: B
NEW QUESTION 96
A team studies a coil steel banding process and makes five changes resulting in productivity improvements of 2%, 2.8%, 2.4%, 2% and 3% respectively. These improvements are best described by which approach to problem solving?
- A. PDCA
- B. Poka yoke
- C. Re-engineering
- D. 5S
- E. Kaizen
Answer: E
NEW QUESTION 97
What is the value of the test statistic?
- A. 3.57
- B. none of the above
- C. 1.251
- D. 0.429
- E. 0.898
Answer: A
NEW QUESTION 98
A valid mathematical Regression represents all of the characteristics shown except _________________.
- A. The Residual is equal to the difference between the observed and predicted values
- B. The residuals when plotted follow a Normal Distribution
- C. Most standardized residuals are within +-2 Standard Deviations
- D. The sum of the residuals is zero
- E. All of the standardized residuals will be within +-3 Standard Deviations
Answer: E
NEW QUESTION 99
A set of data from a process has 8 readings per sample and 50 samples. The mean of the 50 sample means is 12.62. The mean of the 50 ranges is 0.18.Find control limits for the R chart.
- A. 0.10 and 0.25
- B. none and 0.33
- C. 0.02 and 0.33
- D. none of the above
Answer: C
NEW QUESTION 100
A team's goal is to improve information flow in a payroll function. They make thirty-three Post-It@ notes, each listing an issue for further investigation. After some discussion, they group them into four categories: mandated record keeping, privacy concerns, insurance concerns and transfer concerns. This grouping process is best described by which approach to problem solving?
- A. Matrix diagram
- B. Affinity diagram
- C. Process decision program chart
- D. Inter-relationship digraph
- E. Prioritization matrix
- F. Tree diagram
- G. Activity network diagram
Answer: B
NEW QUESTION 101
The English words used for the 5S's are Sorting, Straightening, _____________ , __________ and Sustaining.
(Note: There are 2 correct answers).
- A. Signing
- B. Shining
- C. Standardizing
- D. Shaping
Answer: B,C
NEW QUESTION 102
If item A is more likely to be detected than item B which will have the highest Severity value?
- A. item B
- B. item A
- C. cannot be determined
Answer: C
NEW QUESTION 103
The number of factors, levels and replications:
- A. 3, 2, 2,
- B. 3, 3, 3
- C. 2, 3, 2
- D. none of the above
- E. 3, 2, 3
- F. 2, 2, 2
Answer: E
NEW QUESTION 104
Use this data to calculate the Z Score. Average of: 92, Standard Deviation: 2, Upper Spec Limit: 101
- A. 2.25
- B. 4.50
- C. 0.75
- D. 1.5
Answer: B
NEW QUESTION 105
The Normal Distribution is considered to be the most important distribution in statistics and, among other things is defined as having a total area under the curve of 1, is mounded and symmetrical and the Mean, Median and Mode are _____________.
- A. Twice the Standard Deviation
- B. The same number
- C. Within 10% of each other
- D. All evenly divisible by 3
Answer: B
NEW QUESTION 106
Which statement(s) are correct about the Regression shown here? (Note: There are 2 correct answers).
- A. The predicted number of customers per hour is close to 5 if the outside temperature is 10 deg C
- B. The dashed lines indicate with 95% confidence the estimate for the Quadratic Regression Line
- C. The relationship between outside temperature and number of customers per hour is a Linear Regression
- D. The dependent variable is the outside temperature
- E. The dashed lines indicate with 95% confidence where all of the process data should fall between
Answer: A,B
NEW QUESTION 107
How many experimental runs exist in a Full Factorial and fully randomized design for 4 factors with 2 replicates for the Corner Points and no Center Points? The factors in the experiment are only at 2-levels.
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION 108
When a Belt conducts a Linear Correlation Analysis and finds that as an X increases the Y also
increase then he has proven a ______________ correlation.
- A. Monomial
- B. Positive
- C. Single alignment
- D. Negative
Answer: B
NEW QUESTION 109
......
Get ready to pass the CSSBB Exam right now using our ASQ Certification Exam Package: https://www.practicematerial.com/CSSBB-exam-materials.html
CSSBB Premium Files Test pdf - Free Dumps Collection: https://drive.google.com/open?id=1LrDi_iGBk6JvRwoIKtNFMAHdfa7rvRaC
